UV Resin Class

Explored this technique of ultraviolet harden resin. You will start with a mold or bezel. Carefully pour UV resin into the mold or bezel. You can customize by adding flowers, glitter, charms or other inclusion into the resin. Cure the UV resin with a UV light for 1-7 minutes. Pop it out of the mold and create your one of a kind gorgeous jewelry.

What you need for UV Resin Class will be provided

• Approx. 2 oz of UV Hard Type resin
• 2-3 pinches of glitter, beads, charms, and other inclusions
• Silicone mold for pendants and earrings
• Plastic or silicone measuring cup with 1/2 oz. measurements - you'll only need 1 oz total of resin.
• 2-3 small mixing cups (either paper you can bend or a plastic/silicone cup with a small spout)
• Small plastic mixing spatulas or popsicle sticks
• Toothpicks
• Tool to pop tiny air bubbles - a lighter, small kitchen torch, heat gun, or a straw
• Paper towels
• 91% rubbing alcohol or acetone in a small spray bottle
• Tray or piece of cardstock large enough to fit under your project
• Small scissors
• Pin vise hand drill for resin and 1.5mm or 1.8mm drill bit
• Small cutting board or wood block
• Paper towels
• Two small flat-nose or bent-nose pliers
• Three jump rings (6mm or 7mm)
• 18" necklace chain or whatever length you prefer.
• Two fishhook earrings
• Nitrile gloves
• Protection for your work surface like a plastic sheet, piece of cardboard, or silicone mat
• UV resin lamp
• Optional for your safely: Safety glasses, Long-sleeved shirt, Respirator mask with N95 or equivalent rating